Cleanup
16 3A1177B
Cleanup
1. Engage gun trigger lock.
2. Turn OFF power switch. Turn Prime/Spray valve to
PRIME.
3. Place prime tube in waste pail. Submerge suction
tube in water or compatible solvent for non-water
based material.
4. Turn ON power switch. Align arrow on sprayer and
bucket symbol on pressure control knob.
5. While pump continues to stroke, remove trigger
lock. Trigger gun into paint pail. Turn Prime/Spray
valve to SPRAY. Continue to trigger gun until flush-
ing fluid comes out of gun. Release trigger.
NOTE: To minimize splashing, aim gun at inside
wall of empty waste pail.
6. Move gun to waste pail. Trigger gun until remaining
flushing fluid is gone from flushing pail. Release gun
trigger.
7. Fill unit with Pump Armor or mineral spirits solvent.
See Cleanup, page 16.
ti2048a
ti2018a
ti2019a
ti2050a
ti2028a
ti2051a
ti2052a
To Next Page
Loading...
Need help?
General
