Jog Mode
312065V 33
Jog Mode
Jog mode has two purposes:
• It can speed fluid heating during circulation.
• It can ease pump repair/replacement. See repair
manual.
1. Turn main power on .
2. Ensure motor is OFF (LED is off; display
may show dashes or pressure).
3. Press to select J1 (jog speed 1).
4. Press motor to start motor.
5. Press or to change jog speed (J1
through J10).
NOTE: Jog speeds correlate to 3-30% of motor power,
but will not operate over 700 psi (4.9 MPa, 49 bar) for
either A or B.
6. To exit jog mode, press until display shows
dashes or current pressure.
To Next Page
Loading...
Need help?
General
