EasyManuals Logo

Graco TrueCoat 360 VSP User Manual

Graco TrueCoat 360 VSP
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
Spraying
3A9014A 17
Spray Pattern Quality
A good spray pattern is evenly distributed
without voids or runs. Adjust sprayer Speed
Control (if available), hand speed, and distance
from the wall to get a good spray pattern.
If tails persist, material may need to be
thinned. If material needs to be thinned,
follow manufacturers recommendations.
Spray Angle
Use a piece of scrap cardboard to practice
these basic spraying techniques before you
begin spraying the surface.
Hold sprayer 10-12 inches (25-30 cm)
from surface and aim straight at surface.
Tilting the sprayer to direct the spray
angle causes an uneven finish.
Flex wrist to keep sprayer pointed
straight. Fanning sprayer to direct spray
at angle causes uneven finish.
NOTE: How fast you move the sprayer will
affect spray application. If material is
pulsating, you are moving too fast. If material
drips, you are moving too slow. See
Troubleshooting, page 26.
Aiming Sprayer
Aim the sprayer at the bottom edge of the
previous stroke, overlapping each stroke by
50%.
Triggering Timing
Pull Trigger after starting stroke. Release
Trigger before end of stroke. Sprayer must
be moving when Trigger is pulled and
released.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Graco TrueCoat 360 VSP and is the answer not in the manual?

Graco TrueCoat 360 VSP Specifications

General IconGeneral
Power SourceElectric
Adjustable SpeedYes
Voltage120V
Spray PatternAdjustable
Nozzle Sizes Included1
Adjustable PressureYes
TypeAirless
Tip Size0.015 inches
Orifice Size0.015 inches
MaterialPlastic, Metal
Spray Tip Sizes Included0.015 inch

Related product manuals