Graco TrueCoat 360 VSP User Manual

Cleanup
22 3A9014A
Cleaning Sprayer
Cleaning your sprayer properly and after
every spray job is of the utmost importance!
Proper care and maintenance will make your
paint sprayer last and work for you trouble
free.
1. Turn Prime Knob down to PRIME
position to relieve system pressure.
2. Remove cup assembly from sprayer,
and remove Pump Filter. Set sprayer on
a rag.
3. Remove Cup Lid and pour extra paint
back into paint can. Clean all parts with
warm water.
NOTE: Be sure to clean inside the VacuValve
reservoir. If the VacuValve air hole becomes
clogged, use a paper clip to clean hole.
4. To circulate cleaning fluid, fill clean cup
assembly half-full of cleaning fluid and
reattach to sprayer.
a. Verify the Prime Knob is pointed
down to the PRIME position.
b. Set Speed Control to highest
setting available.
c. Turn the sprayer upside down and
trigger for 15 seconds.

Graco TrueCoat 360 VSP Specifications

General

Power Source	Electric
Adjustable Speed	Yes
Voltage	120V
Spray Pattern	Adjustable
Nozzle Sizes Included	1
Adjustable Pressure	Yes
Type	Airless
Tip Size	0.015 inches
Orifice Size	0.015 inches
Material	Plastic, Metal
Spray Tip Sizes Included	0.015 inch