Warnings
3A9014A 5
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this
equipment. The exclamation point symbol alerts you to a general warning and the hazard
symbols refer to procedure-specific risks. When these symbols appear in the body of this
manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols
and warnings not covered in this section may appear throughout the body of this manual where
applicable.
GROUNDING INSTRUCTIONS
This product must be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electric current.
This product is equipped with a cord having a grounding wire with an appropriate
grounding plug. The plug must be plugged into an outlet that is properly installed
and grounded in accordance with all local codes and regulations.
• Improper installation of the grounding plug is able to result in a risk of electric
shock.
• This product is for use on a nominal 120 V circuit and has a grounding plug
similar to the plugs illustrated in the figure below.
• Only connect the product to an outlet having the same configuration as the
plug.
• Do not modify the plug provided. If it does not fit the outlet, have the proper
outlet installed by a qualified electrician.
• Do not use a 3-to-2 adapter with this product.
• When repair or replacement of the cord or plug is required, do not connect the
grounding wire to either power terminal.
• The wire with insulation having an outer surface that is green with or without
yellow stripes is the grounding wire.
• Check with a qualified electrician or serviceman when the grounding
instructions are not completely understood, or when in doubt as to whether the
product is properly grounded.
Extension Cords:
• Use only a 3-wire extension cord that has a grounding plug and a grounding
receptacle that accepts the plug on the product.
• Make sure your extension cord is not damaged.
• If an extension cord is necessary, use 12 AWG (2.5 mm
2
) minimum to carry the
current that the product draws. An undersized cord results in a drop in line
voltage and loss of power and overheating.
To Next Page
Loading...
Need help?
General
