Operation
33
Basic function settings
Stacking – 10 slices – 4 stacks (= pressed “X button“ 3 times)
When it is started, the machine slices 4 stacks of 10 slices and places them on the table.
Then the machine stops.
Example for continuous mode:
Basic function settings
Stacking – 10 slices – 4 stacks (= pressed “X button“ 3 times)
When it is started, the machine places 4 stacks of 10 slices on the table.
The machine then returns to its initial position and repeats the cutting process.
It continues to do this until one of the following events happens:
x The specified number of portions has been sliced.
x All of the food has been sliced.
x The operator cancels the slicing process.
You can specify the portions in continuous mode (repeat mode).
To do this, use the -/+ arrow buttons to specify the number of portions.
If you specify “0”, the machine will repeat the process until the food has been sliced or
the operator cancels the slicing process.
Another way to modify the continuous slicing mode is to add pauses between individual
portions. The pauses can be used to remove one portion from the table and add a new
film or tray for a new portion on the tray.
3.4.2.4. Pause
This menu item only appears if the continuous mode is active.
This is where you can define the pauses between the individual portions by using the -/+
buttons.
3.4.3. Slicing in the PLU Mode
Customer-specific placing patterns can be stored in the PLU programmes.
Specify “Slicing in Standard Mode” when you are preparing the machine and when you
feed in the food to be sliced.
From the programme selection onwards, proceed as follows:
To Next Page
Loading...
