Use Direct IP Call Mode
Configures enable/disable direct IP call mode of the phone. If set to “Yes”,
the feature of direct IP call will be enabled.
Use Quick IP-Call mode
Sets the phone system to automatically fills in the first three octets to make
an outbound IP call. If it is set to “Yes”, users can dial an IP address under
the same LAN/VPN segment by entering the last octet in the IP address. To
dial quick IP call, offhook the phone and dial XXX (X is 0-9 and XXX
<=255), the phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. XX or X are also valid so leading 0 is not required (but OK). No SIP
server is required to make quick IP call. This setting can be configured after
enabling "Use Direct IP Call Mode" option. The default setting is “No”.
Use Paging Call Mode
Configures enable/disable paging call mode of the phone. If set to “Yes”,
the feature of paging call will be enabled.
Enable Call-Waiting
Enables the call waiting feature. If it is not checked, the phone system will
reject the second incoming call during an active session without user’s
knowledge. But this missed call record will be saved to remind users. The
default setting is “Yes”.
Enable Call-Waiting Tone
Sets the phone system to play the call waiting tone if there is another
incoming call. If it is set to “No”, the phone will only display the indicator
on the LCD screen for another incoming call. The default setting is “Yes”.
Enable DND Reminder
Ring
Enables the DND reminder ring. If set to “Yes”, the ring splash that
indicates an incoming call when DND is enabled will be played. Default
setting is “Yes”
Enable Transfer Enables the Transfer function. Default settings is “Yes”.
Hold Call Before
Completing Transfer
When set to “Yes” the phone holds the second call before completing the
attended transfer (it sends the INVITE method to hold the call before
sending the REFER method).
Default Transfer Mode
Sets the default transfer mode for the phone system. If the Blind Transfer or
Attended Transfer mode is set, the phone system will use the specific mode
to transfer an active call. The users still have privilege to switch the mode
on the LCD screen when they tap the transfer key.
The default setting is “Blind Transfer”.
Enable transfer via non-
Transfer Programmable
Key
Programmable Key with the type speed dial, BLF and speed dial via active
account will perform as transfer programmable keys under active call. The
transfer mode during the call depends on the “Default Transfer Mode”
mentioned above. MPK can also be selected as forward/transfer destination
on the ringing screen when [Enable Function for Incoming Call] is set to
“Call Transfer”.
Preferred Default
Account
Selects the preferred default account for on-hook or off-hook dialing. When
the selected account is unavailable, the system will use the first available
account to dial out. “Auto” automatically selects the last used account to
dial.
The Default value is "Auto"
Special Function for
Incoming Call
Enables the preview feature for the incoming video calls. Defines the
function for the incoming video call.
– If it is set to “Preview”, the phone system will pop up the PREVIEW key
on the LCD screen when there is an incoming video call, and users could
tap on it to check video caller without answering the incoming video call
(the call will keep playing ringback on the caller side).
Note: By pressing the preview button, the phone will send the SIP 183
message to the caller’s camera, based on SIP RFC3261; the caller’s camera
should start sending the stream to the phone upon receiving the SIP 183.
At any time, the GXV3350 user can press the “Answer” button. If done,
then the phone will send the SIP 200OK and call will be fully established.
To Next Page
Loading...
