– If set to “Call Transfer”, the phone system will pop up the “TRANSFER”
key on the LCD screen when there is an incoming call, and users could tap
on it to show up the dialer without answering the incoming call, then, users
could transfer this incoming call to others.
The default setting is “None”.
Enable Conference
Enables the conference. When set to “No”, the phone will block the
conference application. The default setting is “Yes”.
Auto Conference
Allows the phone system to invite all call parties into a conference by
pressing the Conf key. If it is disabled, the end user has to add each call
party to conference manually. The default setting is “No”.
Auto Mute on Entry
Configures whether to mute the call on entry automatically.
● If set to “Disable“, then do not use auto mute function.
● If set to “Auto Mute on Outgoing Call“, then mute automatically when
the other party answers the outgoing call.
● If set to “Auto Mute on Incoming Call“, then mute automatically when
answers the incoming call; If set to “Mute on Incoming & Outgoing
Call”, then mute automatically when the call gets through.
Note: This function only take effect when the phone is from the idle status
to call status. Users could click the Mute button on call interface to cancel
the current mute status.
Always Ring Speaker
Determines if the speaker will play the ringtone if the speaker channel is not
set as default channel. If set to “Yes”, the phone will force to play the ring
speaker in speaker channel. The default setting is “No”.
End user might need this feature when the headset is connected.
Offhook Auto Dial
Configures the User ID/extension to dial automatically when the phone is
off-hook. The phone will use the first account to dial the configured
numbers out. The default setting is “No”.
Offhook Auto Dial Delay
(s)
Defines the timer for warm line dialing. After the timer expires, the phone
system will dial the configured number in Off-hook Auto Dial
automatically. If it is not configured, the configured number will be dialed
immediately.
Offhook/OnHook
Timeout (s)
If configured, the phone will exit the dial-up screen when timeout after
Offhook or Onhook. default is 30s. The valid range is 10-60s.
Handset Option
Configures the Handset options and can be set to:
● If set to “Enable”: when off hook, the phone will enter into the dial
screen, and the media channel will switch to the handset; no matter if
any third app is opening.
● If set to “Disable”: The Handset will be disabled.
● If set to “Auto”: when the 3rd-party application is calling, only the
media channel will switch to the handset when off hook; otherwise, the
phone will enter into the dial screen, and the media channel will switch
to the handset.
Default setting is “Auto”.
Auto Unhold When Press
the Line Key
Configures when there are multiple lines, whether to UnHold the line
automatically when click the line being held and hold the line in the
primary call.
Note: the hold situation which is set manually will not be put on hold
automatically. The default setting is “No”.
Virtual Account Group
Avaya Mode
If set to “Yes”, when processing SIP Register 3XX Response, it will parse
the address site in 3XX, modify the account server info “SIP Server: port”
& “SIP Transaction” in virtual account group and initiate registration again.
This feature is designed for the Avaya customers.
Number of Accounts The
Virtual Account Group
Configures the number of concurrent the main server and standby server
register, each account supports 1 SIP main server and 4 standby server
To Next Page
Loading...
