Day of the Week(0-6)
Defines the day of the week to check HTTP/TFTP/FTP server for firmware.
Upgrade or configuration files changes. The default value is 1.
Randomized
Automatic Upgrade
Randomized Automatic Upgrade within the range of hours of the day or postpone the upgrade every X minute(s)
by random 1 to X minute(s).
The default setting is “No”
Firmware Upgrade
and Provisioning
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
Changes, Always Skip the Firmware Check.
The default setting is “Always Check for New Firmware”.
Firmware Upgrade
Confirmation
If set to “Yes”, the phone will ask the user to upgrade. If there is no response, the phone will proceed with the
upgrade.
If set to “No”, the phone will automatically upgrade without user input.
Default is Yes.
DHCP Option
Allow DHCP Option
43 and Option 66
Override Server
DHCP option 66 originally was only designed for TFTP server. Later, it was extended to support an HTTP URL.
GRP phones support both TFTP and HTTP server via option 66. Users can also use DHCP option 43 vendor
specific option to do this. DHCP option 43 approach has priorities. The phone is allowed to fall back to the
original server path configured in case the server from option 66 fails. The default setting is “Yes”.
Allow DHCP Option
120 to override SIP
Server
Enables DHCP Option 120 from local server to override the SIP Server on the phone. The default setting is
“No”.
Enable DHCP Option
150
Configures whether to enable DHCP Option 150.
this option is used to specify the address of the TFTP (Trivial File Transfer Protocol) server that the phone
should use to download its configuration files and firmware updates.
Enabled by Default.
Enable DHCP Option
160
Configures whether to enable DHCP Option 160.
This option is used to specify the path to the phone's configuration file on the provisioning server.
Enabled by Default.
Enable DHCP Option
161
Configures whether to enable DHCP Option 161.
DHCP Option 161 is used to specify the address of a boot server or provisioning server that the phone should
use to download its configuration files and firmware updates.
Enabled by Default.
Config Provision
Download and Process
ALL Available Config
Files
By default, device will provision the first available config in the order of cfgMAC, cfgMAC.xml,
cfgMODEL.xml, cfg.xml and devMAC.cfg (corresponding to device specific, model specific, and global
configs). If set to Yes, device will download and apply (overwrite) all available configs in the same order.
User Protection When user protection is on, pvalues that user sets will not be changed by provision or provider.
3CX Auto Provision Phone will multicast SUBSCRIBE for provision if this feature is enabled.
Manual Provision
Provision Start provision process for both firmware and config files.
Advanced settings
To Next Page
Loading...
Need help?
General
