Grandstream Networks GRP2616 Administration Guide

GRP2600 Administration Guide
Version 1.0.5.15
P a g e | 65
Allowed in DND Mode
Allow Multicast Paging when DND mode is enabled.
Default Setting is “No”.
Paging Barge
During active call, if incoming multicast page is higher priority (1 being the
highest) than this value, the call will be held and multicast page will be
played. The default setting is “Disabled”.
Paging Priority Active
If enabled, during a multicast page if another multicast is received with higher
priority (1 being the highest) that one will be played instead. The default
setting is “Enabled”.
Multicast Paging
Codec
The codec for sending multicast pages, there are 5 codecs could be used:
PCMU, PCMA, G.726-32, G.729A/B, G.722 (wide band), G.723.1. Default
setting is “G.722(wide band)”.
Multicast Channel
Number
Multicast Channel Number (0-50). 0 for normal RTP packets, 1-50 for
Polycom multicast format packets.
Multicast Sender ID
Outgoing caller ID that displays to your page group recipients (for multicast
channel 1 – 50).
Multicast Listening
Defines multicast listening addresses and labels. For example:
• “Listening Address” should match the sender’s Value such as
“237.11.10.11:6767”
• “Label” could be the description you want to use.
For details, please check the “Multicast Paging User Guide” on our Website.
Settings → Outbound Notification
Action URL
For detailed instruction for this part, please refer to [OUTBOUND
NOTIFICATION SUPPORT] section in this Administration Guide.
• Setup Completed
• Registered
• Unregistered
• Register Failed
• Off Hook
• On Hook
• Incoming Call
• Outgoing Call
• Missed Call
• Answered Call
• Rejected Call
• Forwarded Call
• Established Call
• Terminated Call
• Idle to Busy

Grandstream Networks GRP2616 Specifications

General

Brand	Grandstream Networks
Model	GRP2616
Category	IP Phone
Language	English