Grandstream Networks GXP1160 - Making and Managing Phone Calls

FIRMWARE VERSION 1.0.7.4 GXP1160/GXP1165 USER MANUAL Page 18 of 67
Navigation Keys/Menu.
 Press the 4 navigation keys to move
up/down/left/right;
 Press the round button in the center to enter
Keypad Configuration MENU when phone is in
idle;
 The round button "MENU" can also be used as
ENTER key when in Keypad Configuration.
Volume. Press "-" or "+" to adjust the volume.
0 - 9, *, #
Standard phone keypad.
MAKING PHONE CALLS
HANDSET, SPEAKER AND HEADSET MODE
The GXP1160/GXP1165 allows users to switch among handset, speaker or headset when making calls.
Press the Hook Switch to switch to handset; press the Headset softkey to switch to headset; or press the
Speaker button to switch to speaker.
2 CALLS WITH 1 SIP ACCOUNT
GXP1160/GXP1165 can support up to two lines "virtually" mapped to one SIP account. By picking up the
handset, the GXP1160/GXP1165 will be in off hook state and the dial tone will be heard. To make a call,
dial out the number with the current line.
During the call, users can press the FLASH key to hold the current call and make/answer another
call. If they are 2 calls established, users can switch the two lines by pressing the FLASH key .
COMPLETING CALLS
There are several ways to complete a call on GXP1160/GXP1165.
 On hook dialing. Enter the number when the phone is on hook and then send out.
When the phone is in idle, enter the number to be dialed out;
Take handset off hook; or
Press Speaker button; or