FIRMWARE VERSION 1.0.7.4 GXP1160/GXP1165 USER MANUAL Page 57 of 67
STUN Server
Under Settings->General Settings, enter a STUN Server IP (or FQDN) that you may have, or look up
a free public STUN Server on the internet and enter it on this field. If using Public IP, keep this field
blank.
Use Random Ports
It is under Settings->General Settings. This setting depends on your network settings. When set to
"Yes", it will force random generation of both the local SIP and RTP ports. This is usually necessary
when multiple GXPs are behind the same NAT. If using a Public IP address, set this parameter to
"No".
NAT Traversal
It is under Accounts X->Network Settings. Default setting is "No". Enable the device to use NAT
traversal when it is behind firewall on a private network. Select Keep-Alive, Auto, STUN (with STUN
server path configured too) or other option according to the network setting.
WEATHER UPDATE
To customize GXP1160/GXP1165 to display weather information for the preferred city, users could go to
web GUI->Settings->Web Service page and enter the city code in the following options:
Figure 5: Weather Update
By default the City Code is set to "Automatic", which allows the phone to obtain weather information
based on the IP location detected. To use "Self-Defined City Code" option, please follow the steps below
to obtain the correct city code:
In a web browser, go to www.weather.com;
To Next Page
Loading...
