Grandstream Networks GXP1160 User Manual

FIRMWARE VERSION 1.0.7.4 GXP1160/GXP1165 USER MANUAL Page 46 of 67
Disable Call Waiting Tone
Disables the call waiting tone when call waiting is on. The default setting
is "No".
Disable Direct IP Call
Disables Direct IP Call. The default setting is "No".
Use Quick IP Call mode
When set to "Yes", users can dial an IP address under the same
LAN/VPN segment by entering the last octet in the IP address. To dial
quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No
SIP server is required to make quick IP call. The default setting is "No".
Disable Conference
Disables the Conference function. The default setting is "No".
Disable in-call DTMF Display
When it's set to "Yes", the DTMF digits entered during the call will not
display. The default setting is "No".
Enable MPK sending DTMF
Enables Multi Purpose Key to send DTMF during the call. The default
setting is "No".
Disable Transfer
Disables the Transfer function. The default setting is "No".
In-call dial number on pressing
transfer key
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
Auto-Attended Transfer
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Do Not Escape # as %23 in
SIP URI
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Click-To-Dial Feature
Enables Click-To-Dial feature. The default setting is "Disabled".
Blink message LED on ringing
Message LED light will blink if there is an incoming call. Default value is
“No”.
Call History Flash Writing:
Write Timeout
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Call History Flash Writing:
Max Unsaved Log
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)

Grandstream Networks GXP1160 Specifications

General

Brand	Grandstream Networks
Model	GXP1160
Category	IP Phone
Language	English