Change Bluetooth Device Name
The GXV3370 uses "GXV3370XXXXXX" as Bluetooth device name by default where “XXXXXX” are the
last 6 digits of the phone’s Bluetooth MAC address. The device name will be visible to other devices when
connecting them. Follow the steps below to change the name:
1. Go to GXV3370's Settings→Basic→Bluetooth
2. Turn on Bluetooth.
3. Select Additional settings.
4. Press "Device name".
5. Enter a name and tap on "Rename".
Pair GXV3370 with a Bluetooth Device
Before connecting GXV3370 with other Bluetooth device, users must pair them first. They will stay paired
afterwards unless they are unpaired.
1. Go to GXV3370's Settings → Basic → Bluetooth
2. Turn on Bluetooth.
3. Tap Additional settings and select “Visible to nearby Bluetooth devices” to make the GXV3370 phone
visible to all nearby Bluetooth devices.
4. The GXV3370 scans and displays the IDs of all available Bluetooth devices in range. If the device you
would like to pair with does not show up in the list (available devices), ensure that the other device is
turned on and set to be discoverable.
5. If the GXV3370 stops scanning before the other device is ready, press button to scan again.
6. Once the Bluetooth device shows up in the result, tap on it to start pairing. Confirm the passkey in the
prompted message (if any). Or if passcode is required, please refer to the device's documentation or
other procedures to obtain the passcode.
To Next Page
Loading...
Need help?
General
