Figure 60: GXV3370 Conference - Remove Party from Conference
End Conference
To end the conference, tap on to disconnect all the parties from the conference. GXV3370 will hang
up the call. If the remote party hangs up the call itself, it will be disconnected from the conference but other
parties on GXV3370 will stay in the existed conference.*
Hold and Resume Conference
During the conference, users could tap on More softkey then tap on Hold to hold the conference at any
time. To resume the call tap on Unhold.
Auto Conference Mode
The GXV3370 also supports "Auto Conference" which allows users to establish conference call in a quick
and easy way, instead of adding the other parties one by one. To enable Auto Conference feature, go to
web GUI→Phone Settings→Call Settings→Call Features and set "Auto Conference" to "Yes".
To esablish call with auto conference when there are 1 or more calls on the GXV3370, simply tap on "More"
softkey and select "Conf". All the calls on GXV3370 will be brought into the conference.
Note:
• During the conference, if the initiator of the conference hangs up , the conference will end. If users wish
to allow the remaining parties to stay in conversation after the initiator hangs up, the conference initiator
should set "Transfer on 3-way Conference Hang up" to "Yes" in web GUI→Account→Call Settings.
This would allow the remaining parties to stay in the conference after the initiator exists the conference.