Account Page Definitions
GXV34x0 phones has 16 lines that can be configured to accommodate 16 independent SIP accounts. Each account has an
individual configuration page.
Account/SIP/General Settings
Account Registration
Account Active Indicates whether the account is active. The default value for the first account is “Yes”.
Account Name Configures the name associated with each account to be displayed on the LCD.
SIP Server
Specifies the URL or IP address, and port of the SIP server. This should be provided by VoIP service
provider (ITSP).
SIP User ID
Configures user account information provided by your VoIP service provider (ITSP). It’s usually in
the form of digits similar to phone number or actually a phone number.
SIP Authentication
ID
Configures the SIP service subscriber’s Authenticate ID used for authentication. It can be identical
to or different from the SIP User ID.
SIP Authentication
Password
Configures the account password required for the phone to authenticate with the ITSP (SIP) server
before the account can be registered. After saving, it will appear as hidden for security purpose.
Display Name
Specifies the SIP server subscriber’s name (optional) that will be used for Caller ID display. The
configured content will be included in the From, Contact and P-Preferred-Identity headers of SIP
INVITE message.
Tel URI
Indicates E.164 number in “From” header by adding “User=Phone” parameter or using “Tel:” in SIP
packets, if the phone has an assigned PSTN Number.
Disabled: Will use “SIP User ID” information in the Request-Line and “From” header.
User=Phone: “User=Phone” parameter will be attached to the Request-Line and “From” header
in the SIP request to indicate the E.164 number. If set to “Enable”.
Enabled: “Tel:” will be used instead of “sip:” in the SIP request.
Please consult your carrier before changing this parameter. Default is “Disabled”.
Voice Mail Access
Number
Sets if the phone system allows users to access the voice messages by pressing the MESSAGE key on
the phone. This ID is usually the VM portal access number. For example, in UCM6xxx IPPBX, *97
could be used.
Network Settings
Outbound Proxy
Configures the IP address or the domain name of the primary outbound proxy, media gateway or
session border controller. It’s used by the phone for firewall or NAT penetration in different network
environments. If a symmetric NAT is detected, STUN will not work and only an outbound proxy can
provide a solution
Secondary
Outbound Proxy
Sets IP address or domain name of the secondary outbound proxy, media gateway or session
border controller. The phone system will try to connect the Secondary outbound proxy only if the
primary outbound proxy fails.
To Next Page
Loading...
Need help?
General
