Grandstream Networks GXV34 0 Series

Table 39: System Settings/Preferences
System Settings/TR-069
Enable TR-069
Sets the phone system to enable the “CPE WAN Management Protocol” (TR-069).
The default setting is “Yes”.
ACS URL
Specifies URL of TR-069 ACS (e.g., http://acs.mycompany.com), or IP address.
Default setting is “https://acs.gdms.cloud”
ACS User Name Enters user name to authenticate to ACS.
ACS Password Enters password to authenticate to ACS.
Periodic Inform Enable
Sends periodic inform packets to ACS.
Default is “Yes”.
Periodic Inform Interval (s)
Configures to sends periodic “Inform” packets to ACS based on specified interval.
Default setting is 86400.
Connection Request User Name Enters user name for the ACS to connect to the phone.
Connection Request Password Enters password for the ACS to connect to the phone.
Connection Request Port Enters the port for the ACS to connect to the phone.
CPE Cert File Uploads Cert File for the phone to connect to the ACS via SSL.
CPE Cert Key Uploads Cert Key for the phone to connect to the ACS via SSL.
Table 40: System Settings/TR-069
Maintenance Page Definitions
Maintenance/Upgrade
Maintenance/Upgrade/Firmware
Enable Handset
Noise Shield 2.0
When Handset Noise Shield feature is enabled, the remote party will hear less environmental noise
during a call. If set to "High Shielding", most of the environmental noise can be shielded. If set to "Soft
Shielding", some environmental comfort noise will remain for the remote party.
Handfree TX Gain
(dB)
This feature congures the transmission gain for handsfree mode. Default setting is “0dB”.
-16
-12
-8
-4
0
+4
+8
+12
+16
Media Volume Congures the volume of media.
Alarm Volume Congures the volume of alarm.
Ringtone Volume Congures the volume of ringtone.
Upgrade via Manually Upload
Complete Upgrade
If enabled, all les will be replaced except user data.
Default is disabled.