System Number
Specifies the door system number which is the SIP user ID configured on door system or its IP
address, if the door system is using IP call. It enables to show open door button when caller number
or IP address matches with this setting. e.g:”36311″ or “192.168.124.81”.
Note: When set “Door System Type” to “Baudisch” a “configure” button will appear to allow user to
configure groups of door system URL and User ID for 100 entries.
System Number: This is used to configure the User ID of door system. Once configured, only
the call from this User ID would use door system while other calls use the default mode.
System Address: This is used to input the IP address or URL of the system in order to identify
the call from door system.
Users can set HTTP authentication credentials on the URL for Door Systems that require
authentication to send HTTP stream. The URL format will be similar to the following:
http://username:password@192.168.1.150/goform/stream?cmd=get&channel=4
Display Name
Configures the display name of the door system. When the call matches the configured system
number, the name will be displayed on LCD.
Related Display
Name1
Configures the name that will be displayed on LCD for door 1 when the call matches the configured
GDS door system number.
Access password
Determines the door system password which should match the one configured on the used door
system settings. In case the GDS is set as ‘Door System type’ parameter, the password should match
the one configured on the GDS to open door 1.
Related Display
Name2
Indicates the name that will be displayed on LCD for door 2 when the call matches the configured
system number.
Access password The configured password should match the one configured on the GDS to open door 2.
System Ringtone
Allows users to configure the ringtone for the door System. Users can choose different ringtones
from the dropdown list.
DTMF Content
Set the DTMF content that is going to be sent when the DTMF button is pressed under Call
screen🡪“Keypad”.
General Settings
Display Open Door
Button when
Calling
Configures whether display Open Door button when there is an incoming call. If set to “Yes”, you
cannot open door with DTMF when preview function is disabled, the phone will hide open door
button automatically.
Enable Preview
Configures whether to enable preview function or not. If set to “No”, you cannot open door with
DTMF when there is an incoming call, the phone will hide open door button automatically.
Table 51: Value-added Service/Value-added Service
UPGRADING AND PROVISIONING
The GXV34x0 phones can be upgraded via TFTP/HTTP/HTTPS by configuring the URL/IP Address for the TFTP/HTTP/HTTPS
server and selecting a download method. Configure a valid URL for TFTP, HTTP or HTTPS; the server name can be FQDN or IP
address.
Examples of valid URLs:
firmware.grandstream.com/BETA
firrmware.grandstream.com
Upgrade and Provisioning Configuration
There are two ways to setup upgrade and provisioning on GXV34x0 phones. They are Keypad Menu and Web GUI.
Configure via keypad Menu
In GXV34x0 Settings, select Advanced 🡪 System Updates.
To Next Page
Loading...
