Grandstream Networks GXV34 0 Series

Advanced Settings
Country Code
Configure Wi-Fi country code. The default value is “United States of America”.
Note: Reboot is required to take effect.
Table 32 :Network Settings/Wi-Fi Settings
Network Settings/OpenVPN® Settings
Table 33: Network Settings/OpenVPN® Settings
Network Settings/Advanced Network Settings
Advanced Network
Settings
Enable OpenVPN®
This enables/disables OpenVPN® functionality and requires the user to have access to an
OpenVPN® server. The default setting is No. NOTE: To use OpenVPN® functionalities, users
must enable OpenVPN® and congure all the settings related to OpenVPN®, including server
address, port, OpenVPN® CA, certicate and key. Additionally, the user must also set the SIP
account to use “OpenVPN” for the “Nat Traversal” (under Account-> General Settings->
Network Settings).
OpenVPN® Mode
Simple mode only supports some basic or common parameters conguration; Professional
mode suppports conguration le upload, which is totally customized by need, please refer to
https://openvpn.net for more information.
Enable OpenVPN® Comp-lzo
Enables OpenVPN® LZO compression. When the LZO compression is enabled on the
OpenVPN® server, you must turn on it at the same time. Otherwise, the network will fail to
connect.
OpenVPN® Server Address The URL/IP address for the OpenVPN® server.
OpenVPN® Port
The network port for the OpenVPN® server.
By default, it is set to 1194.
OpenVPN® Transport
Determines network protocol (UDP or TCP) used for OpenVPN®.
Default is UDP.
OpenVPN® CA
OpenVPN® CA le (ca.crt) required by the OpenVPN® server for authentication purposes.
Press “Upload” to upload the corresponding le to the device. The le will not be uploaded if it
is not in the correct format.
OpenVPN® Client Certicate
OpenVPN® Client certicate le (*.crt) required by the OpenVPN® server for authentication
purposes. Press “Upload” to upload the corresponding le to the device. The le will not be
uploaded if it is not in the correct format.
OpenVPN® Client Key
The OpenVPN® Client key (*.key) required by the OpenVPN® server for authentication
purposes. Press “Upload” to upload the corresponding le to the device. The le will not be
uploaded if it is not in the correct format.
OpenVPN® Cipher Method
The cipher method of OpenVPN®, must be the same cipher method used by the OpenVPN®
server. Available options are: “Blowsh”, “AES-128” or “AES-256”. Default is “Blowsh”.
OpenVPN® User Name OpenVPN® authentication username (optional).
OpenVPN® Password OpenVPN® authentication username (optional).