Grandstream Networks GXV34 0 Series

Table 27: Phone Settings/Call Settings
Phone Settings/Ringtone
Table 28: Phone Settings/Ringtone
Phone Settings/Video Settings
Virtual Account
Group Concurrent
Registration
Congures the amount of concurrent accounts in virtual account group. If the total amount of virtual
group accounts is “N”, the number of accounts the user sets is “n”, then the phone will register the rst
n accounts; If registration for all of these accounts failed, then register the last N-n accounts. The
default value is 2
Filter Characters
Sets the characters for lter when dial out numbers. Users could set up multiple characters. For
example, if set to “[()-]”, when dial (0571)-8800-8888, the character “()-“ will be automatically ltered
and dial 057188008888 directly.
Escape '#' as %23 in
SIP URI
Determines which characters will be included in the SIP INVITE URI if end users input #. If it is set to
“Yes”, the phone will replace the # by %23. Otherwise, it will include # in the SIP INVITE message.
Default is “Yes”.
Auto Cong CPT by
Region
Congures whether to choose Call Progress Tone automatically by region. If set to “Yes”, the
phone will congure CPT (Call Progress Tone) according to different regions automatically. If set
to “No”, you can manual congure CPT parameters.
The default setting is “No”.
Call Progress Tones:
● Dial Tone
● Second Dial Tone
● Ring Back Tone
● Busy Tone
● Reorder Tone
● Conrmation Tone
● Call-Waiting Tone
Congures tone frequencies according to user preference. By default, the tones are set to North
American frequencies. Frequencies should be congured with known values to avoid
uncomfortable high pitch sounds.
Syntax: f1=val,f2=val [,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing (“On time” in “ms”) while OFF is the period of silence. In order to set a
continuous ring, OFF should be zero. Otherwise it will ring ON ms and a pause of OFF ms and then
repeats the pattern.
Please refer to the document below to determine your local call progress
tones:https://www.itu.int/ITU-T/inr/forms/les/tones-0203.pdf
Call-Waiting Tone Gain
Adjusts the call waiting tone volume. Users can select “Low”, “Medium” or “High”.
The default setting is “Low”.
Default Ring Cadence Denes the ring cadence for the phone. The default setting is: c=2000/4000.
Video Frame Rate
Congures video frame rate for SIP video call from “5 frames/second”, “15 frames/second”, “25
frames/second” and “30 frames/second”. The default setting is 15 frames/second. The video
frame rate is adjustable based on network conditions. Increasing the frame rate will signicantly
increase the amount of data transmitted, therefore consuming more bandwidth. The video quality
will be affected due to packet loss if extra bandwidth is not allocated.
Video Display Mode Congures the video display mode to "Original proportion", "Cut proportionally" or "Add black
margin proportionally".
1. Original proportion:the phone displays video in its original proportion. Note:If the video
display proportion is different from the one of the phone, the phone will stretch or compress
video to display it.