Remote Control Pop
up Window
Support
Configures whether the phone is enabled to pop up allow remote control window. If set to “Yes”,
when the remote console is connected to the phone, the phone will pop up a window to allow
remote control or not. If set to “No”, once the remote console successfully connect s to the phone,
it can directly control the phone remotely.
Action URI Allow IP
List
List of allowed IP addresses from which the phone receives the Action URI. If input “any”, any
remote console can access this phone.
Table 34: Network Settings/Advanced Network Settings
Network Settings/SNMP Settings
Table 35 : Network Settings/SNMP Settings
Network Settings/Affinity Settings
Table 36: Network Settings/Affinity Settings
System Settings Page Definitions
System Settings/Time and Language
Enable SNMP Configures whether to enable SNMP.
Version Selects SNMP version from the drop-down list.
Port Configures the port for SNMP.
Username Configures username for SNMPv3.
Security Level Selects security level for SNMPv3.
Trap Version Selects trap version of SNMP trap receiver.
Trap IP Version Configures IP address of SNMP trap receiver.
Trap Port Configures the port of SNMP trap receiver.
Trap Interval(m) Configures the interval between each trap sent to the trap receiver.
Trap Community
Configures community name associated to the trap. It must match the community name of the trap
receiver.
Affinity Support
Configures whether to enable the Affinity feature. Note: The Affinity CTI function can only be used
when the phone has a registered account.
Preferred Account Selects SIP account for Affinity.
Defines the URL or IP address of the NTP server. The phone may obtain the current date and time
To Next Page
Loading...
Need help?
General
