Grandstream Networks GXW-4024 User Manual

Grandstream Networks, Inc. GXW4024 User Manual Page 28 of 35
Firmware 1.0.1.8 Last Updated: 5/2008
Disable Call
Waiting Tone
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting call arrives.
The CWCID will still be displayed.
Disable
Visual MWI
Visual message indicator is a special on-hook caller ID type message that enables and
disables the message waiting light on certain phones. GXW4024 has this feature enabled by
default. However, certain phones (rare) that do not support it may mistakenly treat this CID
signal as an incoming call. A configuration option is needed to turn on MWI in this case.
Ring Timeout
Incoming call will stop ringing when not picked up given a specific period of time.
Hunting Group
Ring Timeout
Default is 20 seconds. If call is not answered within this designated time period, the call will
be forwarded to the next member of a Hunt Group.
Delayed Call
Forward Wait Time
Default value is 20 seconds. In case this feature activated using * codes (*92 code), the call
will be forwarded after this preconfigured amount of time.
No Key Entry
Timeout
Default is 4 seconds. Call will be completed within this time interval if no additional key entry
occurs.
Early Dial Default is No. Use only if proxy supports 484 response. This parameter controls whether the
phone will send an early INVITE each time a key is pressed when a user dials a number. If
set to “Yes”, an INVITE is sent using the dial-number collected thus far; Otherwise, no
INVITE is sent until the “(Re-)Dial” button is pressed or after about 5 seconds have elapsed if
the user forgets to press the “Re-Dial” button. The “Yes” option should be used ONLY if
there is a SIP proxy configured and the proxy server supports 484 Incomplete Address
response. Otherwise, the call will likely be rejected by the proxy (with a 404 Not Found error).
This feature is NOT designed to work with and should NOT be enabled for direct IP-to-IP
calling.
Dial Plan Prefix
Sets the prefix added to each dialed number.
Use # as Dial Key
Allows users to configure the “#” key as the “Send” (or “Dial”) key. If set to “Yes”, “#” will
send the number. In this case, this key is essentially equivalent to the “Dial” key. If set to
“No”, this “#” key can be included as part of number.

Grandstream Networks GXW-4024 Specifications

General

Brand	Grandstream Networks
Model	GXW-4024
Category	Gateway
Language	English