If enabled, the gateway will broadcast SIP SUBSCRIBE message during
booting up to allow itself to be discovered and be configured by the SIP
server.
Choose “Yes” to enable automatic upgrade and provisioning. When set to
No, GXW400X will only do upgrade once at boot up.
When “Check every day” or “Check every week” is checked, user can specify
“Hour of the day (0-23)” or “Day of the week (0-6)”. Default time is Monday
1AM.
There are three options to choose from: “Always check for New Firmware at
Boot up”, “Check New Firmware only when F/W pre/suffix changes”, and
“Always Skip the Firmware Check”.
Disable SIP NOTIFY
Authentication
Device will not challenge NOTIFY with 401 when set to Yes.
If set to Yes, configuration file is authenticated before being accepted. This
protects the configuration from unauthorized modifications.
For firmware encryption. It should be 32-digit in Hexadecimal
Representation. End user should keep it blank.
The GXW400X series supports SIP over TLS. It has built-in private key and
SSL certificate. The user specified SSL certificate used for SIP over TLS is in
X.509 format.
You may also customize the SSL Private Key. The user specified SSL private
key used for SIP over TLS is in X.509 format.
SIP TLS Private Key
Password
Enter SSL Private Key password here.
To Next Page
Loading...
Need help?
General
