Configure the delay time for offhook auto-dial function. Range is 0-60 seconds,
default is 0.
This is used only when peering with a Grandstream GXW410x. Default is 1,
Supported values are 1-8, meaning line 1 to line 8 of the GXW410x device
where the port will be mapped to.
This is used when peering with an FXO gateway of any brand. You have to
specifically mention the IP and sip port where the call will be sent to.
Sip port that will be annexed to the IP address above.
Table 12: Profile settings
When set to Yes the SIP Profile is activated.
Primary SIP Server’s IP address or Domain name provided by VoIP service
provider.
Failover SIP Server’s IP address or Domain name provided by VoIP Service
provider. This server will be used if the Primary SIP server becomes unavailable.
Prefer Primary SIP
Server
Default is no. If set to yes it will register to Primary Server if registration with
Failover server expires
IP address or Domain name of Outbound Proxy, or Media Gateway, or Session
Border Controller. Used by GXW400X for firewall or NAT penetration in different
network environments. If symmetric NAT is detected, STUN will not work and
ONLY outbound proxy can correct the problem.
To Next Page
Loading...
Need help?
General
