Default value is 20 seconds. In case this feature activated using * codes (*92
code), the call will be forwarded after this preconfigured amount of time.
Default is 4 seconds. Call will be completed within this time interval if no
additional key entry occurs.
Default is No. Use only if proxy supports 484 response. This parameter controls
whether the phone will send an early INVITE each time a key is pressed when a
user dials a number. If set to “Yes”, an INVITE is sent using the dial-number
collected thus far; Otherwise, no INVITE is sent until the “(Re-)Dial” button is
pressed or after about 5 seconds have elapsed if the user forgets to press the
“Re-Dial” button. The “Yes” option should be used ONLY if there is a SIP proxy
configured and the proxy server supports 484 Incomplete Address response.
Otherwise, the call will likely be rejected by the proxy (with a 404 Not Found
error).
This feature is NOT designed to work with and should NOT be enabled for direct
IP-to-IP calling.
Allows users to configure the “#” key as the “Send” (or “Dial”) key. If set to “Yes”,
“#” will send the number. In this case, this key is essentially equivalent to the
“Dial” key. If set to “No”, this “#” key can be included as part of number.
To Next Page
Loading...
Need help?
General
