Disable Reminder
Ring for On-Hold
Call
Default is No. This is to disable the Reminder Ring that is played when a call is
waiting on hold and the analog phone goes on-hook.
Visual message indicator is a special on-hook caller ID type message that
enables and disables the message waiting light on certain phones. GXW400X
has this feature enabled by default. However, certain phones (rare) that do not
support it may mistakenly treat this CID signal as an incoming call. A configuration
option is needed to turn on MWI in this case.
Do Not Escape '#'
as %23 in SIP URI
If set to “Yes”, device will use ‘#’ instead of %23 in the send URI.
Disable Multiple m
line in SDP
Default is No. If set to Yes, device will send only one m line in SDP, regardless
how many m field in the incoming SDP.
Incoming call will stop ringing when not picked up given a specific period of time.
Hunting Group Ring
Timeout
Default is 20 seconds. If call is not answered within this designated time period,
the call will be forwarded to the next member of a Hunt Group.
Linear and Circular. Linear style will sort the call to the lowest-numbered available
line, this is also called “serial hunting”. Circular style will distribute the calls
"round-robin". If a call is assigned to line 1, the next call goes to 2 and the next
to 3. The succession throughout each of the lines continues even if one of the
previous lines becomes available. When the end of the hunt group is reached,
the hunting starts over at the first line. Lines are skipped if they are still busy on
a previous call. These two hunting styles can be configured from the Profile_x
page.
To Next Page
Loading...
Need help?
General
