3
Set the stock shaft in from the front.
CAUTION
•
During a plotting or cutting operation, be
sure to keep your hands, hair, and so forth
away from the media stocker, gears and
rollers.
•
When you are installing media, be careful for
gear, a roller, etc. not pinch you nger.
•
Deviations and errors may result if the stock
shaft is misaligned when plotting begins.
Align the receiving end of the media shaft with the grooves on the roller and push
down rmly to set it in place.
Stock shaft
Lever
Roller
Groove
Please make sure to set in the direction of the paper.
4
The left and right media anges feed in the paper roll media. Please tighten the
ange screw and fasten the paper roll into the desired position.
5
Lower the media set lever to raise the push rollers.
Push roller
Media set lever
To Next Page
Loading...
