GRAPHTEC CE6000-120AP - Special Precautions on Handling Blades; Cutter Blades; Cutter Pens; After Mounting the Cutter Pen

7
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers"
P.09
about the position of the push rollers.
6
Put the roll media on the roll media tray and then push the tip of the roll media
forward from the back of the machine. Make sure to pull it so that there is no
slackening across the roll media's route.
Media guide
Media sensor
The paper roll media’s route goes over the center bar and behind the media
guide bar.
Media guide bar
Supplement
•
The media must always be positioned over
the media sensor.
•
See "Aligning the Push Rollers"
P.09
about the position of the push rollers.
•
See "Aligning the Push Rollers"
P.09
for
information about center 3 push roller hold-
down force.
7
Position the media and the push rollers to correspond with the width of the media.
Use the 5 push rollers to push down the sides and center of the media.
Use the grit roller position guide and make sure the push rollers are on top of the
grit rollers.
You can adjust the center push roller's hold-down force.
Grit roller position guide
Media sensor
Push roller
Grit roller
Push roller
(The center push roller is near the edge.)
(The center push roller is near the
edge.)
(The push roller is on top of the grit roller.)(The push roller is on top of the grit roller.)
CAUTION
When setting on inside more than 30 mm, cut
cross is not available.
When Feeding Long-axis Media (at exceeds 2 meters)
Position the push rollers at least 15 mm inside the edges of the media.
Push roller
Media
15mm
15mm