CAUTION
When setting on inside more than 30 mm, cut
cross is not available.
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 5 mm inside the edges of the media.
Push roller
Media
5mm
To use a paper wider than 1,119 mm
Carefully set the position of the left edge of the push roller.
Set the right edge of the grit roller between 2 mm and 8 mm.
It's not possible to set the right edge of the grit roller to a size greater than 8 mm. (There is a stopper.)
CAUTION
Notes on the left grit roller
•
The left grit roller is not available in all locations.
•
It’s not possible to set the right edge of the grit roller to a size greater than 8 mm. (There is a stopper.)
•
Please set the push roller to the position between 2 mm and 8 mm from the right edge of the grit roller.
Push roller
Grit roller
Media
Push roller
Grit roller
Media
8 mm or more
OK NG
CAUTION
During a plotting or cutting operation, be sure
to keep your hands, hair, and so forth away
from the media stocker, gears and rollers.
8
Raise the lever to lock.
Lever
9
When removing the paper, please stand to the side of the main assembly and
pull horizontally from the middle of the paper.
10
Pull from the front of the machine to even the tension of both A and B
sides of the paper, as shown in the gure below.
2 mm to 8 mm
5mm
To Next Page
Loading...
