GRAPHTEC CE6000-60 - Page 18

CE6000-UM-251-9370 2-5
2 PARTS NAMES and FUNCTIONS
Front View : CE6000-120
Tool carriage
Tool holder
Control panel
Media set lever
USB interface connector
RS-232C interface connector
Push roller
Media sensor
Cutting mat
Grit roller position guide
Cutting groove
Grit roller
Media guide bar
Media stopper
Control panel ��������������������������������Used to access various plotter functions�
Push rollers ����������������������������������Rollers that push the media against the grit rollers. (Number may vary
depending on the model)
Grit rollers ������������������������������������� Metallic rollers with a le-like surface that feed the media back and
forth�
Media sensors ������������������������������The front sensor is used to sense the leading edge of the media� The
rear sensor is used to sense the trailing edge of the media�
Tool carriage ��������������������������������� Moves the cutter-pen or plotting pen across the media during cutting
or plotting�
Tool holder ������������������������������������Holds the cutter-pen or plotting pen and moves it up or down�
Grit roller position guide ������������� Stickers on the front of the Y rail and the rear side of the top cover that
show the position of each grit roller. Use these alignment marks as an
aid in locating the Push rollers�
Cutting mat �����������������������������������Cutter blade moved on this mat, preventing wears of the blade.
Cutting groove ������������������������������Use this groove when using the media cutter�
Media set lever �����������������������������Used to raise or lower the Push rollers during the loading or unloading
of media�
USB interface connector ������������� Used to connect the plotter to the computer with a USB interface
cable.
RS-232C interface connector �����Used to connect the plotter to the computer with a RS-232C interface
cable.
Media stopper ������������������������������� This stops the stock shaft from spinning when setting in media.
It is also utilized when pulling roll media straight out�
Media guide bar ���������������������������� Used to keep media straight when setting it in.