CE6000-UM-251-9370 6-39
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the cutting mat base assembly
(1) Clean the surface of the base frame with alcohol where the cutting mat base assembly was
attached.
(2) Attach the new cutting mat assembly to the base frame to the following position.
(3) Insert the three sheets of 0.7 mm shim to the left, the center, and the right between the drive roller
and the base frame.
And then position the cutting mat base assembly to be touched to the three shims.
And the space between the front edge of Cutting mat base assembly and the front edge of base
frame must have 0.3±0.2 mm when the cutting mat base assembly is positioning.
And position the right edge of cutting mat base assembly at the 2.5 mm from the right side plate.
Removes the protection sheets from the cutting mat base assembly and then puts the cutting mat
base assembly to the location above.
Cutting mat base assembly
0.7 mm shim
Cutting mat base assembly
2.5 mm
Right side plate
Cutting mat base assembly
0.7 mm shim
0.3 ±0.2 mm
Base frame
To Next Page
Loading...
