SETUP MANUAL
MANUAL NO.CE6000-UM-8M4
CUTTING PLOTTER
CE6000 SERIES
Preface
Thank you for choosing this product. Carefully keep this manual in a handy location for quick reference as necessity
prior to use to ensure safe and correct use and also to thoroughly understand the functions and operate them
effectively.
Prior to use
Be sure to read the attached "TO ENSURE SAFE AND CORRECT USE" prior to use. Otherwise, it may cause an
unexpected accident or re.
Notes on this Manual
(1) No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means,
without the prior written permission of Graphtec Corporation.
(2) The product specications and other information in this manual are subject to change without notice.
(3) While every effort has been made to provide complete and accurate information, please contact your sales
representative or nearest Graphtec vendor if you nd any unclear or erroneous information or wish to make other
comments or suggestions.
(4) Notwithstanding the stipulations in the preceding paragraph, Graphtec Corporation assumes no liability for damages
resulting from either the use of the information contained herein or the use of the product.
Registered Trademarks
All names of companies, brands, logotypes, and products appearing in this manual are the trademarks or registered
trademarks of their respective companies.
Copyright
This User's Manual is copyrighted by Graphtec Corporation.
Roles of each manual
•
Setup Manual (this manual) Read it to understand Displaying method for User's Manual, Method for connecting
this Cutting Plotter with the PC, Installing method for controller driver software, and to
prepare for the operation.
•
User's Manual (PDF data) Read it to thoroughly understand the functions.
•
Cutting Plotter Controller Manual (PDF data)
Read it to run the software "Cutting Plotter Controller" for operation of this Cutting
Plotter through your PC.
621588810
To Next Page
Need help?
General
