GRAPHTEC CE6000 SERIES - To Make 1 Cut with Set Value

11
6. Tool adjustment and test cutting
After setting the Tool/Speed/Force/Acceleration, make test cutting, and repeat until optimal condition is achieved.
CAUTION
Do not touch the Tool edge when power is
turned on or during operation.
1 Load the media for test cutting in the plotter.
2 Press the [COND/TEST] key in the default screen.
In Normal mode, CONDITION screen (1/3) is displayed.
In Simple mode, CONDITION screen (1/5) is displayed.
CONDITION screen
(Normal mode)
CONDITION screen
(Simple mode)
Setting the Tool conditions
For more information about the various cutting
conditions, see “Selecting Tool Condition”.
3 Set the Tool conditions (Tool, Speed, Force, Acceleration).
Ex.) TOOLS CONDITION
Settings screen (Normal mode)
Ex.) TOOLS CONDITION
Settings screen (Simple mode)
To make 1 cut with set value
4 Make test cutting for one piece while Tool conditions are
being set.
CONDITION screen
(Normal mode)
CONDITION screen
(Simple mode)
(1) Press the POSITION ( ) key (CUT TEST).
(2) Press the POSITION ( ) key the tool carriage
to the location you wish to perform the test cutting.
Tool carriage
CAUTION
When the [ENTER] key is
pressed, the tool carriage
will start moving, so take
care not to cut your ngers.
Press the [ENTER] key.
Cut test pattern is cut.
To make 3 cuts with set value and ±1 of set value
4 Make test cutting for three pieces while Tool conditions
are being set.
CONDITION screen
(Normal mode)
CONDITION screen
(Simple mode)
(1) Press the POSITION ( ) key (CUT TEST).
CUT TEST screen is displayed.
CUT TEST screen
(Normal mode)
CUT TEST screen
(Simple mode)
(2) Press the POSITION ( ) key the tool carriage
to the location you wish to perform the test cutting.
(3) Press the [1] key (FORCE).
Cut Order
+1 Setting
values
–1
3 cutting test patterns are cut,
with current FORCE in the
center, and 1 each of FORCE
increased and decreased for 1
(4) Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
(5) Press the [2] key (CUTTER OFFSET). (Normal mode
only)
3 cutting test patterns are cut, with current CUTTER
OFFSET in the center, and 1 each of CUTTER OFFSET
increased and decreased for 1.
(6) Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.