Why does the push roller go off the media on my GRAPHTEC Plotter?
If one of the push rollers goes off the media on your Graphtec Plotter, it's likely that the leading or trailing edge of the media is not cut straight against the media. To resolve this, cut the edge of the media straight.
What to do if GRAPHTEC CE6000 Plotter stops with "POSITION ALARM" during cutting?
If the Graphtec Plotter displays "POSITION ALARM" during initialization or cutting, it could be due to several reasons. The CONDITION setting for the media might be invalid, so try slowing down the speed or lowering the FORCE. An object might be disturbing the pen carriage; remove any obstructions and restart the plotter. External force applied to the pen carriage or media chaff in the operation area can also cause this, so remove any obstacles and restart. If none of these solutions work, the plotter may be defective, and you should contact your sales representative or the Graphtec call center.
Why is my GRAPHTEC Plotter cutting on the grit roller imprint?
If your Graphtec Plotter is cutting on the grit roller imprint, it means the cutting width has been widened. To resolve this, revert the expand limit to the default setting.
What does error E01011 mean on GRAPHTEC CE6000?
If the Graphtec Plotter displays error code E01011, the plotter is defective. Contact your sales representative or the Graphtec call center for assistance.
Why are there too many tool up and down movements on my GRAPHTEC Plotter?
If there are too many tool up and down movements on your Graphtec Plotter, the setting for tangential emulation is likely set to ON. Turn OFF the setting for tangential emulation unless you are cutting thick media.
What does error E01001 mean on GRAPHTEC CE6000 Plotter?
If the Graphtec Plotter displays error code E01001 to E01005, the plotter is defective. Contact your sales representative or the Graphtec call center for assistance.
What does command error mean on GRAPHTEC CE6000?
If the Graphtec Plotter displays a command error, it means the data sent to the plotter is not correct. Check the data to ensure it is properly formatted and compatible with the plotter.
Why can't my GRAPHTEC Plotter cut above a certain length?
If your Graphtec Plotter cannot cut above a certain length, it means the length of the cut is exceeding the page length set on the plotter. Press the [FAST] key to check the cutting area and match the setting for the page length.
What does error E01006 mean on GRAPHTEC Plotter?
If the Graphtec Plotter displays error code E01006, the plotter is defective. Contact your sales representative or the Graphtec call center for assistance.
How to fix coarse resolution of curved lines on GRAPHTEC CE6000?
If you're experiencing coarse resolution of curved lines on your Graphtec Plotter, it could be due to the software's resolution setting being too low or the blade offset angle being too low. Try adjusting the software's resolution setting and increasing the value for the blade offset angle.
General| Connectivity | USB, Serial |
|---|---|
| Cutting Force | 30-500 gf |
| Interface | USB |
| Media Types | Vinyl, film |
| Display | LCD |
| Configuration | Desktop |
| Programmable Resolution | 0.025 mm |
| Repeatability Precision | ±0.1 mm |
| Command Sets | GP-GL / HP-GL |
| Power Supply | AC 100-240 V, 50/60 Hz |
| Media Thickness | Up to 0.25 mm (0.01 in) including liner for die-cut, Up to 0.5 mm (0.02 in) for plotting |
| Operating System Compatibility | Windows |
| Number of Push Rollers | 2 |
| Pen Compatibility | Yes |
To Next Page
