CE6000-UM-251-9370 7-32
7 ELECTRICAL ADJUSTMENTS
7.13 Adjusting the Offset between Tool 1 and Tool 2 (CE6000-120AP)
This adjustment will set the tool offset position.
If you replace the main board, use the following procedure to input the recorded adjustment values.
How to adjust the tool exchange position
(1) Mount the ball point pens onto the 1st-tool holder and 2nd-tool station.
(2) Load an A4 size sheet of paper into the plotter.
(3) Turn on the power while pressing the FAST and ENTER keys.
(4) Select the Language and the Length Unit if the Language selection menu is displayed (See section
7.5.).
(5) Press the PAUSE/MENU key at the following menu.
(6) The following menu is displayed, and then press the right arrow key (ADJ).
(7) The following menu is displayed.
(8) Press the up arrow key until the following menu is displayed.
(9) Press the F1 key to display the menu shown below.
To Next Page
Loading...
