CE6000-UM-251-9370 7-12
7 ELECTRICAL ADJUSTMENTS
7.8 Adjusting the Distance Accuracy
This adjustment will set the distance accuracy.
If you replace the main board, use the following procedure to input the recorded adjustment values.
If you replace the grit roller, you must adjust the distance accuracy using the following procedure.
How to adjust the distance accuracy
(1) Mount a ball-point pen into the pen holder.
(2) Load a sheet of A3 size paper into the plotter.
(3) Turn on the power while pressing the FAST and ENTER keys.
(4) Select the Language and the Length Unit if the Language selection menu is displayed (See section
7.5.).
(5) Press the PAUSE/MENU key at the following menu.
(6) The following menu is displayed, and then press the right arrow key (ADJ).
(7) The following menu is displayed.
(8) Press the F3 key (DISTANCE ADJUST) to display the following menu.
To Next Page
Loading...
