GRAPHTEC CE6000 SERIES - Vacuum Fan for the CE6000-40;60

CE6000-UM-251-9370 6-32
6 DISASSEMBLY AND REASSEMBLY
6.2.17 Vacuum Fan for the CE6000-40/60
How to detach the vacuum fan
(1) Detach the right cover (See section 6.1.1.).
(2) Detach the front guide (See section 6.1.4.).
M3L35 binding head screw
Access the screw from this square hole.
Fan
(3) Remove the harness tie-wrap holding the vacuum fan cable.
(4) Disconnect the vacuum fan cable from the connector on the main board.
(5) Use a long screwdriver to remove the two M3L35 binding head screws holding the vacuum fan
from the holes of the bottom chassis.
(6) Detach the vacuum fan from the main unit.
How to reinstall the vacuum fan
(1) Reattach in the reverse order in which it was detached.