GRAPHTEC CE6000 SERIES - Adjusting the Tool Exchange Position (CE6000-120 AP)

CE6000-UM-251-9370 7-29
7 ELECTRICAL ADJUSTMENTS
7.12 Adjusting the Tool Exchange Position (CE6000-120AP)
This adjustment will set the tool exchange position.
This adjustment is used for the 2nd tool exchange.
If you replace the main board, use the following procedure to input the recorded adjustment values.
How to adjust the tool exchange position
(1) Turn on the power while pressing the FAST and ENTER keys.
(2) Load an A4 size sheet of paper into the plotter.
(3) Select the Language and the Length Unit if the Language selection menu is displayed (See section
7.5.).
(4) Press the PAUSE/MENU key at the following menu.
(5) The following menu is displayed, and then press the right arrow key (ADJ).
(6) The following menu is displayed.
(7) Press the up arrow key until the following menu is displayed.
(8) Press the F2 key (TOOL2 EXCHANGE ADJ). The following menu is displayed.