GRAPHTEC CE6000 SERIES - X-Motor for the CE6000-40;60

CE6000-UM-251-9370 6-24
6 DISASSEMBLY AND REASSEMBLY
6.2.14 X-motor for the CE6000-40/60
How to detach the X-motor
(1) Detach the right side cover (See section 6.1.1.).
(2) Detach the front guide (See section 6.1.4.).
(3) Detach the main board (See section 6.2.13.).
(4) Remove the three M3L6 binding head screws holding the X-motor, and then detach the X-motor.
M3L6 binding head screw
X Motor
(5) Disconnect the X-motor relay cable from the X motor.
(6) Disconnect the X-Motor encoder cable from the X motor.
(7) Loosen the two M3L4WP set screws holding the X-motor pulley, and then detach the X-motor
pulley.
M3L4WP set screw
X motor