CE6000-UM-251-9370 6-11
6 DISASSEMBLY AND REASSEMBLY
6.2.6 Pen Block
How to detach the pen block
(1) Detach the center cover (See section 6.1.3.).
(2) Loosen the M3L6 binding head screw holding the pen block cover.
Pen block cover
M3L6 binding head screw
(3) Detach the pen block cover.
(4) Disconnect the cable from connector J504 on the Y-relay board.
(5) Disconnect the exible cable from connector J505 on the Y-relay board.
(6) Remove the two M4L8 binding head screws holding the pen block.
Pen block
M4L8 binding head screw
(7) The registration mark sensor board and sensor cable are not including in the parts of pen block.
To Next Page
Loading...
