CE6000-UM-251-9370 6-19
6 DISASSEMBLY AND REASSEMBLY
6.2.11 Y-belt
How to detach the Y-belt
(1) Detach the right side cover (See section 6.1.1.).
(2) Detach the left side cover (See section 6.1.2.).
(3) Detach the center cover (See section 6.1.3.).
(4) Detach the pen block (See section 6.2.6.).
(5) Loosen the M3L6 TP head screw attaching the Y-tension arm.
(6) Pull the Y-tension arm in the direction of the arrow as shown below, then detach the Y-tension
spring hook from the left side plate.
M3L6 TP head screw
Y belt tension spring
Y belt tension arm
Y belt tension bracket
(7) Tighten the M3L6 TP head screw attaching the Y-tension arm while pulling the Y-tension arm.
The Y belt tension loosen with the Y-tension arm of pulling position.
(8) Remove the four M3L6 binding head screws holding the right and left Y-belt stopper plates to the
slider.
M3L6 binding head screw
Y belt stopper plate
Y belt
(9) Detach the Y-belt.
To Next Page
Loading...
