CE6000-UM-251-9370 6-20
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the Y-belt
(1) Hang the Y-belt on both sides of the pulley.
(2) Attach both ends of the Y-belt to the Y-slider so that four notches of the Y-belt îš¿t into the Y-slider,
then attach with the Y-belt stopper plates removed in step (6) in the previous subsection.
M3L6 binding head screw
Y belt stopper plate
Y belt
(3) Reinstall the other parts in the reverse order in which they were detached.
(4) The Y belt tension is automatically adjusted with the Y belt tension spring.
Loosen the M3L6TP head screw îš¿xing the position of the Y belt tension.
Move the pen block to the far right side, and then tighten the M3L6TP head screw to îš¿x the
position of the Y belt tension.
M3L6 TP head screw
Y belt tension spring
Y belt tension arm
Y belt tension bracket
To Next Page
Loading...
