CE6000-UM-251-9370 7-30
7 ELECTRICAL ADJUSTMENTS
(9) Press the F2 key (CHECK POS) to move the pen carriage to the exchange position.
(10) Press the F3 key (Y ADJUST) to display the following menu to adjust the gap.
(11) Measure the gap between the 2nd tool holder and the 2nd tool station.
(12) Adjust gap using the up or the down arrow key. Adjust gap to 1 mm between the 2nd tool holder and
the 2nd tool station.
This gap should be 1 mm.
2nd Tool Holder
2nd Tool Station
(13) Press the left arrow key after the gap is adjusted. The following menu is displayed.
(14) Press the F2 key (CHECK POS) twice to conîš¿rm the adjusted gap.
(15) Press the F4 key to display the following menu to adjust the 2nd tool holder height.
To Next Page
Loading...
