CE6000-UM-251-9370 7-31
7 ELECTRICAL ADJUSTMENTS
(16) Adjust the 2nd tool holder height by using the up or the down arrow key.
Adjust tool holder height to be same height with the 2nd tool holder and the 2nd tool station.
The height of 2nd tool
holder should be same
level to the 2nd tool
station.
2nd Tool Holder
2nd Tool Station
(17) Press the left arrow key after the height is adjusted. The following menu is displayed.
(18) Press the F2 key (CHECK POS) twice to conîš¿rm the adjusted height.
(19) Mount a îš¿ber tip pen in the 2nd tool station.
(20) Press the right arrow key to conîš¿rm that the pen exchanging is performed correctly.
(21) If the pen exchanging is performed correctly, press the ENTER key to store the setting and complete
the adjustment.
To Next Page
Loading...
