GRAPHTEC CE6000 SERIES - Page 125

CE6000-UM-251-9370 7-28
7 ELECTRICAL ADJUSTMENTS
(15) Press the ENTER key after conrmed the position of front edge of adjustment sheet.
The front square hole edge of adjustment sheet moves to as shown in the picture below.
Cutting mat base
Conrm the front square hole edge of adjustment sheet come to this
groove area of cutting mat base.
The front square hole edge of adjustment sheet
(16) Press the ENTER key after conrmed the position of front square hole edge of adjustment sheet.
(17) Press the ENTER key to store the value after the following menu is displayed.
(18) Turn off the power.