GRAPHTEC CE6000 SERIES - Attaching a Tool

3
1. Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a Tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its ange contacts the upper part of the holder and then tighten the screw
rmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or whenever the tool
is moving.
For details, see “Attaching a Tool” on in User’s Manual.
It is explained here using cutter plunger as an example.
CAUTION
When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut your ngers.
Supplement
•
When using with half cutting and plotter pen, set the seal in Tool Holder 1 (backward), and when using cutting out (perforated cut), set
the seal in Tool Holder 2 (forward).
•
Cutting out means that the media is cut out completely.
•
Half cutting means that only the marking lm is cut out, leaving the backing sheet uncut.
1 Loosen the tool holder screw.
Tool holder
Bracket to hold tool
Bracket to hold tool
Tool holder
Top
Supplement
When using with half cutting and plotter pen,
set the seal in Tool Holder 1 (backward), and
when using cutting out (perforated cut), set the
seal in Tool Holder 2 (forward).
2 While pushing up the tool holder, push until its ange completely touches
the upper part of the holder.
Flange
Bracket to
hold tool
Tool holder 1
(Backward : Half cutting/Plotting Pen)
Tool holder 2
(Forward : Using
cutting)
Tool holder
Setting up the Plotter main unit