GRAPHTEC CE6000 SERIES - About the Initial Setup Screen

10
4. About the Initial Setup screen
The Initial Setup screen appears only when powering up the Cutting Plotter for the rst time after purchase. Here, you can
set "Display Language" and "Length Unit".
After the initial setup is completed, you can also select the menu from the READY status.
See "Connecting to the Power" for turning on the power.
1 Once the machine is powered on (with the " | " switch) a message will be displayed after the version is displayed.
Here, PLEASE DISPLAY LANGUAGE setting screen is displayed.
2 Use the POSITION ( ) keys to select the language.
(This manual assumes you chose the English language setting.)
3 Press the [ENTER] key.
After the DISPLAY LANGUAGE is selected, the LENGTH UNIT screen will appear.
4 Press the [1] key (METRIC) or the [2] key (INCH) to select the length unit setting.
5 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and the default screen is displayed.
5. Set the media type into the Plotter.
Set the media type into the Plotter depending on the preset media.
CAUTION
Release the media stopper.
Supplement
The CONTINUE menu parameter appears when
the media set lever is raised and then lowered
again after media was previously loaded, making
it possible to select the previous settings.
1 If you have already loaded the media, the MEDIA TYPE menu appears.
Select the media type to suit the loaded media.
Roll media
Plot starting with the edge of
media.
[1] ROLL-1 FRONT EDGE
Plot starting with the preset
position.
[2] ROLL-2 CURRENT POSITION
Sheet media Set a sheet media. [3] SHEET
CONTINUE When similar media is reset [4] CONTINUE
Simple mode/ Normal mode
You can use the [SIMPLE] key on the default
screen to switch between Simple mode and
Normal mode. CE6000 will be reset once when
you switch.
In Simple mode you can change easy settings
from the menu screen.
In Normal mode, you will be able to change
more detailed settings.
Simple mode and Normal mode are independent
from one another. The settings of the mode
you're currently in will take precedence.
For details, see "About Simple mode".
2 After the media is detected, the plotter is ready to receive data for cutting
or plotting. This status is called "READY status" of the default screen.
When setting is nished, the tool carriage's location will become the
initial point.
Dfault screen is displayed.
Menu screen
(Normal mode)
Menu screen
(Simple mode)