CE7000-UM-251-9370 7-34
7 DISASSEMBLY AND REASSEMBLY
How to reinstall the X-motor
(1) Attach the X-motor pulley to the X-motor at the following position. Tighten the two M3L4WP set screws
that hold the X-motor pulley.
X motor
X motor pulley
3.5 mm
(2) Spread a suitable quantity of Loctite 222 on the two M3L4WP set screws that hold the X-motor pulley.
(3) Attach the X motor to the right side plate.
(4) Hang the X-drive belt on the X-drive pulley.
(5) Perform the X-drive belt tension adjustment (Refer to subsection 7.3.3.).
(6) Reattach the other parts in the reverse order in which they were detached.
(7) Conrm the wiring for X motor cables (Refer to subsection 7.4.).
To Next Page
Loading...
