CE7000-UM-251-9370 7-63
7 DISASSEMBLY AND REASSEMBLY
When the adjustment position was not marked adjust the X drive belt tension by the following
procedure.
(1) Push the belt 2 mm using a force gauge as shown in the picture below.
2 mm
550 g
CE7000-40/60
2 mm
600 g
CE7000-130/130AP/160
(2) Adjust the position of X-motor that X drive belt is pushed 2 mm by 550 g force for the CE7000-40/60.
Adjust the position of X-motor that X drive belt is pushed 2 mm by 600 g force for the CE7000-
130/130AP/160.
(3) Tighten the three M3L6 binding head screws holding the X motor.
(4) Spread a suitable quantity of the Shinetu silicon grease G501 on the X-motor pulley.
To Next Page
Loading...
