CE7000-UM-251-9370 8-30
8 Electrical Adjustment
(5) Press the PAUSE/MENU key to display the following menu.
(6) Press the Right position key to display the adjustment menu shown below.
(7) Press the Up position key to display the following menu.
(8) Press the F1 key to display the following menu.
(9) Press the F2 key to display the following menu.
(10) Move the tip of tool to the center of the white square by using the position keys as shown below.
LOA
D MEDIA TO FC9000 (SHEET
)
MOVE TOO
L POSITION TO CENTER OF WHITE SQUARE
.
REGISTRATION MARK SENSOR LEVEL ADJUST
(11) Press the ENTER key to start the registration mark sensor gain adjustment. The plotter immediately
adjusts the registration mark sensor gain automatically. And then the following menu is displayed.
To Next Page
Loading...
